noun

definition

Meanings relating to a wind instrument.

definition

Meanings relating to a hollow conduit.

definition

Meanings relating to a container.

definition

Meanings relating to something resembling a tube.

definition

Meanings relating to computing.

definition

Meanings relating to a smoking implement.

verb

definition

To play (music) on a pipe instrument, such as a bagpipe or a flute.

definition

To shout loudly and at high pitch.

definition

To emit or have a shrill sound like that of a pipe; to whistle.

definition

Of a metal ingot: to become hollow in the process of solidifying.

definition

To convey or transport (something) by means of pipes.

definition

To install or configure with pipes.

definition

To dab moisture away from.

definition

To lead or conduct as if by pipes, especially by wired transmission.

definition

To directly feed (the output of one program) as input to another program, indicated by the pipe character (pipe) at the command line.

definition

To create or decorate with piping (icing).

example

to pipe flowers on to a cupcake

definition

To order or signal by a note pattern on a boatswain's pipe.

definition

(of a male) To have sexual intercourse with a female.

definition

To see.

Examples of pipe in a Sentence

His pipe lay broken on the hearth.

The giant pipe ran through a wooded area, away from the cliff edge.

Berg held a smoking pipe between his knees.

Pipe lines supply the city with natural gas.

The coiled pipe firebox of the high-pressure hot-water system previously described may be also classed with boilers.

The trio finally called it a night with the likely hood of restful sleep a pipe dream.

With cast iron pipe this cannot be done, and no length of piping over 40 ft.

The engine turned over and backfired, black smoke frothing out of the tail pipe.

As many as 1200 wires are sometimes enclosed in one lead pipe.

Rostov, smoking his pipe and turning his head about as the water trickled down his neck, listened inattentively, with an occasional glance at Ilyin, who was pressing close to him.

Frequently a single pipe is led to the tap, but the water in this branch cools and must therefore be drawn off before hot water can be obtained.

But, secondly, the pneumatic utterances technically known as speaking with tongues failed to reach this level of intelligibility; for Paul compares "a tongue" to a material object which should merely make a noise, to a pipe or harp twanged or blown at random without tune or time, to a trumpet blaring idly and not according to a code of signal notes.

The genus Hevea was formerly called Siphonia, and the tree named Pao de Xerringa by the Portuguese, from the use by the Omaqua Indians of squirts or syringes made from a piece of pipe inserted in a hollow flask-shaped ball of rubber.

The same string or pipe and the same key have therefore to serve for what should be slightly different notes.

Taps to baths and lavatories should be connected to the main services by a flow and return pipe so that hot water is constantly flowing past the tap, thus enabling hot water to be obtained immediately.

In the ordinary working of a hot-water apparatus the expansion pipe already referred to will prevent any overdue pressure occurring in the boiler; should, however, the pipes Safety become blocked in any way while the apparatus is valves.

To prevent this a safety valve should be fitted on the top of the boiler, or be connected thereto with a large pipe so as to be visible.

A water pipe of copper or wrought iron is passed through a cylinder in which gas or oil heating burners are placed.

The paper cables consist of a number of wires, each enveloped in a loose covering of well-dried paper, and loosely laid up together with a slight spiral " lay " in a bundle, the whole being enclosed in a stout lead pipe.

The cable is then placed in an oven, and, after all moisture has been driven off, it is passed through a lead press whence it emerges protected by a continuous lead pipe.

It is regarded by the Turks as specially valuable, inasmuch as it is said to be incapable of transmitting infection as the pipe passes from mouth to mouth.

With the adoption of carefully fitted screw-joints in 1865 the pipe line gradually came into general use, until in 1891 the lines owned by the various transit companies of Pennsylvania amounted in length to 25,000 m.

Among these lavas is the "pipe" amygdaloid of which many blocks have been transported great distances down the Vaal river.

Direct firing is used for the second boiling of the soap mixture; but for this superheated steam may with advantage be substituted, either applied by a steam-jacket round the pan or by a closed coil of pipe within it.

Shreveport, Oil City, Blanchard, Mooringsport, Bozier City and Texarkana are supplied with natural gas by pipe lines from this field.

The town is first called a borough in the pipe roll of 2 Henry II., when an aid of 20S.

The straw must have a certain length of "pipe" between the knots, must possess a clear delicate golden colour and must not be brittle.

The pipe of the upper joint alone is selected for plaiting, the remainder of the straw being used for other purposes.

Spotted and discoloured straws are dyed either in pipe or in plait.

Split straws are prepared with the aid of a small instrument having a projecting point which enters the straw pipe, and from which radiate the number of knife-edged cutters into which the straw is to be split.

The area of the " pipe " containing blue ground is estimated at 350,000 sq.

Among its manufactures are foundry and machineshop products, boilers, carriages and wagons, agricultural implements, pipe and fittings, working-men's gloves, &c. In 1905 the total factory product was valued at $6,729,381, or 61.5% more than in 1900.

E is a valve in the inlet pipe opening into the cylinder; and A the piston is perforated by one or more holes, each fitted with valves opening outwards on its upper surface.

On again raising the piston, more liquid enters the lower part of the cylinder, whilst the previously raised liquid is ejected from the delivery pipe.

In this case the piston is solid, and the outlet pipe, G which is placed at the bottom of the cylinder, has a valve F opening outwards, the inlet pipe and valve are the same as before.

It is seen that the action is intermittent, liquid only being discharged during a down stroke, but since the driving force is that which is supplied to the piston rod, the lift is only con ditioned by the power available and by the strength of the pump. A continuous supply can be obtained by leading the delivery pipe into the base of an air chamber H, which is fitted with a discharge pipe J of such a diameter that the liquid cannot escape from it as fast as it is pumped in during a down stroke.

The inlet pipe enters an elliptical vessel which communicates with the cylinder a little way up from its base, whilst at the base there is a relief tube leading into the elliptical vessel already mentioned.

Oil is placed both above the upper valve seating, and also in the cylinder up to the height of the lower edge of the inlet pipe.

In Anglo-Saxon and Norman times it possessed a mint, and it is called a borough in the Pipe Rolls of Henry II., but it was not then in a flourishing condition.

Finally, fluid steel can be run or poured off, since it is perfectly fluid, while glass cannot be thus treated, but is withdrawn from the furnace by means of either a ladle or a gatherer's pipe, and the temperature required for this purpose is much lower than.

When this is the case the gathering is carried to a block or half-open mould in which it is rolled and blown until it acquires, roughly, the shape of a hemisphere, the flat side being towards the pipe and the convexity away from it; the diameter of this hemisphere is so regulated as to be approximately that of the cylinder which is next to be formed of the viscous mass.

From the hemispherical shape the mass of glass is now gradually blown into the form of a short cylinder, and then the pipe with the adherent mass of glass is handed.

The lower end of the cylinder is opened, in the case of small and thin cylinders, by the blower holding his thumb over the mouthpiece of the pipe and simultaneously warming the end of the cylinder in the furnace, the expansion of the imprisoned air and the softening of the glass causing the end of the cylinder to burst open.

The blower then heats the end of the cylinder again and rapidly spins the pipe about its axis; the centrifugal effect is sufficient to spread the soft glass at the end to a radius equal to that of the rest of the cylinder.

The finished cylinder is next carried to a rack and the pipe detached from it by applying a cold iron to the neck of thick hot glass which connects pipe-butt and cylinder, the neck cracking at the touch.

A full account of the process of blowing crown-glass will be found in all older books and articles on the subject, so that it need only be mentioned here that the glass, instead of being blown into a cylinder, is blown into a flattened sphere, which is caused to burst at the point opposite the pipe and is then, by the rapid spinning of the glass in front of a very hot furnace-opening, caused to expand into a flat disk of large diameter.

This only requires to be annealed and is then ready for cutting up, but the lump of glass by which the original globe was attached to the pipe remains as the bullion in the centre of the disk of glass.

He remarked that the flow of water from an orifice depends not only on the magnitude of the orifice itself, but also on the height of the water in the reservoir; and that a pipe employed to carry off a portion of water from an aqueduct should, as circumstances required, have a position more or less inclined to the original direction of the current.

At a time when the Cartesian system of vortices universally prevailed, he found it necessary to investigate that hypothesis, and in the course of his investigations he showed that the velocity of any stratum of the vortex is an arithmetical mean between the velocities of the strata which enclose it; and from this it evidently follows that the velocity of a filament of water moving in a pipe is an arithmetical mean between the velocities of the filaments which surround it.

His conditions were agreed to, but after he had fulfilled his promise the inhabitants, on the ground that he was a sorcerer, declined to fulfil their part of the bargain, whereupon on the 26th of June he reappeared in the streets of the town, and putting his pipe to his lips began a soft and curious strain.

Disclaimer

Scrabble® Word Cheat is an incredibly easy-to-use tool that is designed to help users find answers to various word puzzles. With the help of Scrabble Word Cheat, you can easily score in even the most difficult word games like scrabble, words with friends, and other similar word games like Jumble words, Anagrammer, Wordscraper, Wordfeud, and so on. Consider this site a cheat sheet to all the word puzzles you have ever known.

Please note that SCRABBLE® is a registered trademark. All intellectual property rights for the game are owned by Hasbro Inc in the U.S.A and Canada. J.W. Spear & Sons Limited of Maidenhead, Berkshire, England (a subsidiary of Mattel Inc.) reserves the rights throughout the rest of the world. Also, Mattel and Spear are not affiliated with Hasbro. Words with Friends is a trademark of Zynga with Friends.

Scrabblewordcheat.com is not affiliated with SCRABBLE®, Mattel Inc, Hasbro Inc, Zynga with Friends, or Zynga Inc in any way. This site is only for entertainment and is designed to help you crack even the most challenging word puzzle. Whenever you are stuck at a really difficult level of Scrabble or words with friends, you will find this site incredibly helpful. You may also want to check out: the amazing features of our tool that enables you to unscramble upto 15 letters or the advanced filters that lets you sort through words starting or ending with a specific letter.

Top Search